How to Wrap with Precut PPF Kits

Installing your Precut PPF is easy—even for beginners! Follow these simple steps for a clean, bubble-free finish and lasting protection.

🛠️ What You’ll Need:

• Spray bottle with soapy water

• Squeegee (included with most kits)

• Microfiber cloth

• Heat gun or hairdryer (optional for curves)

✅ Step-by-Step Installation Guide:

1. Clean the Surface
Wash the area thoroughly. Remove all dust, wax, and grease. The surface must be completely clean and dry.

2. Spray Application Area
Spray the soapy water on the surface and the adhesive side of the film. This allows you to position the film easily.

3. Place the Film
Align the pre-cut film to your vehicle panel. Use reference points (like edges and curves) for accurate placement.

4. Squeegee Out Bubbles
Use the squeegee to press out water and air bubbles from the center outward. Work gently to avoid creases.

5. Heat and Seal (if needed)
For curved areas, apply gentle heat using a heat gun or hairdryer. This helps the film conform and stick better.

6. Final Touch
Wipe off any remaining water with a microfiber cloth. Let the film cure for 24–48 hours without washing the car.

📦 Pro Tip:

Install in a clean, shaded area to avoid dust and direct sunlight during application.

Need help or guidance?
📞 Call us at 0553441687
📧 Email: Precut.ae@gmail.com